Na Píobairí Uilleann

[FergusM]

I am about to make Regulator reeds for my Wide bore 'D' Andreas Rogge Full set .

I have the Reg reed dimensions from Dave Hegarty Uilleann Pipe Reed Maker's Guide book and also Allan Moller has reg reed dimensions on this reedmaking video.

I need some more dimensions for the Tenor and Baritone reg reeds. This is for cane reeds not Bronze Regulator Reeds.

On Andreas Rogge website it says "The concert pitch instrument is based upon an instrument by Leo Rowsome"

I am looking for reg reed measurements for tenor and baritone. All the three reg reeds on my A. Rogge 'D' wide bore set use staples with 3.2mm inside dia.

All I need is
Staple length, eye width.
Over all length of reed
Head width
Head length
Scrape length
Over all cane slip length
tail length
How far to insert staple in tails.


Cheers

Ferg